All of our truck bed racks are made model specific to ensure the best possible fit and therefore are non-transferable to pickups with different box sizes.
If stake pockets are present, no drilling is required. However, trucks without stake pockets will require drilling.
Absolutely, ADARAC™ Truck Bed Racks can be installed within an hour by one person, times will vary depending on ability level. Check out our easy to follow Instructions and helpful Installation Videos.
We only offer a matte black or silver finish.
The maximum weight capacity is 1,000 lbs. parked static, 500 lbs. dynamic and 400 lbs. offroad dynamic, evenly distributed.
Yes, most aftermarket accessories utilizing an in-channel mounting system, over-channel clamping system or U-bolt clamps will be compatible, yet a longer mounting bolt may be needed to properly secure onto the ADARAC™ Cross Bars.
Yes, our truck bed racks are designed to work with LOMAX® Folding Hard Covers, ACCESS® Roll-Up Covers and most inside the rail tonneau covers.
To determine if an ADARAC™ Truck Bed Rack is compatible with your tonneau cover, measure from the center of the stake pocket 1-1/8" towards inside of box, to ensure this area is clear of obstructions.
Yes, however, some trimming or cutting of an over the rail bed liner may be required.
No, an over-the-rail toolbox will interfere with how the ADARAC™ Truck Bed Rack mounts to your truck.
Of course! Our ADARAC™ Overland Accessories are engineered to fit onto new and existing ADARAC™ Aluminum Series, ADARAC™ Aluminum Pro Series and ADARAC™ Aluminum M-Series. ADATRAC™ End Caps required to install ADATRAC™ Accessories on ADARAC™ Aluminum Pro Series.
ADAGRID™ Accessories - Yes, most aftermarket overlanding accessories using an in-channel mounting system, U-bolt clamps or over-channel clamping system will be compatible, but may require a longer bolt to properly secure onto accessory bars. ADATRAC™ Accessories - Yes, most aftermarket overland accessories utilizing 1/2" and 3/8" square nuts will be compatible.
Yes, additional ADATRAC™ Mounting Brackets are engineered to work with corner mounted overland accessories.
Yes, additional ADAGRID™ Mounting Plates are designed to work with bolt-on tents, cargo baskets and other platform accessories.
We currently only offer matte black.
No, ADARAC™ Overland Pickup Accessories create no extra wind noise!
Check Shop by Truck to see if we have a rack for your truck.
Fill out our Warranty Claims Form. A Customer Service Representative will contact you within 48 hours
You can purchase Replacement Parts Online or call our Customer Service Department at 877-708-4787 to place an order.
You can order directly from our factory or visit one of our dealers. Use our Dealer Locator and find the nearest dealer to you.
Yes, Visit our Online Store.
You can order directly from the factory using our Online Store.
The Serial Number is located toward the rear on the driver's side rack rail.
A 1 Year Limited Warranty applies to all ADARAC™ Truck Bed Racks and Overland Accessories.